|
Details of the 103003 update |
|||
Auto HD/SD input switching-
For both the
Vision and VisionPro you can now have the processor auto switch between HD
passthru and processing SD video for satellite/cable boxes which receive both HD
and SD channels. Per aspect zoom settings- Previously zoom was only valid for the current input memory and if you changed the input aspect or inputs it would be reset to no zoom. Now, each aspect for each input memory will remember whatever zoom level you've set it to and it's also saved when you perform a save command. Higher refresh rates available- You can now go up to 120 Hz refresh at 600p. It can not currently genlock at these higher rates. At resolutions greater than 600p refresh rates higher than previously allowed are also available.
Test pattern additions- A warmup test pattern is new under the MISC->TPAT menu area. This test pattern will fill the screen with gray at 40 IRE (can be adjusted up or down from 20-50 IRE) and will stay on until "exit" is pressed on the remote in order to warmup your CRT. Red,Green, and Blue test pattern fields were added to the test pattern selection. Disable "NO SIGNAL" screen- when no signal is detected the screen is cleared and the "NO SIGNAL" message is displayed. If you wish to disable this and just display whatever is coming in even if it's not a clean signal press "menu",0,9,6,4 to toggle it off/on. 1024p bug fix- crt parameters were incorrectly set. 1080p bug fix - Input aspect of 1.85 on output aspect of 1.78 did not previously work at 1080p, it does now. |
|||
Lumagen, Vision, and VisionPro are
trademarks of Lumagen Inc. |